![]() It’s much easier to just use a BEC board that comes with a naked GoPro case, but some prefer to use an external BEC as it’s more reliable and robust against voltage spikes that can fry the GoPro. When measurements were taken, front screen was attached but the back touch screen was not. When it’s recording (2.7K 60FPS), it draws about 0.95A (4.7W). When the camera is turned on and in idle, it draws about 0.5A current (2.6W). The GoPro Hero 9 motherboard takes 5V input. The original GoPro 9 uses a ribbon cable that split the connector into two, and you will need it to connect the touch screen. Note that there’s only one connector for the touch screen on the main board, but there’re two connectors on the touch screen. Make sure you connect the touch screen this way, if you reverse the connection you could potentially fry the GoPro. ![]() Use this diagram at your own risk, it’s for my own reference only. The camera can be powered via the USB module, then hold down power button to see if the GoPro powers on, is there image showing on the screen? Finally try recording to see if it functions normally.Īll works? Congrats! You just made yourself a naked GoPro! Motherboard Pin-out Once you finished the tear down, you should test it by connecting the lens module, touch screen and buttons to the logic board.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |